Zero defects is the requirement, not the aspiration
Three challenges we see most often
- Customers audit down to PPM
- Traceability required on every part
- Frequent model changeovers per order
Best-fit solutions
These three tie together on an automotive line: camera results are bound to machine state to give per-part traceability, and vibration data warns you before a die starts producing scrap.
Relevant standards
IATF 16949, and evidence capture for 8D reports
What to watch out for on site
Shiny metal parts reflect light badly enough to make inspection hard, so you need diffuse or dome lighting — roughly ฿15,000–30,000 more per position depending on the site survey. We tell you at the assessment stage, not later.
Example test results
We do not yet have finished test figures for sink-mark and flash inspection on injection-moulded parts — they are being collected. We will not substitute results from another industry.
Not sure whether this fits your industry?
A free 30-minute call. We will tell you straight if your problem is not a good fit for AI yet.
Talk to us for 30 minutes firstSee all industries